SBC1
Gm Built Engine. I only export this engine as internal shipping cost makes domestic purchase impractical.
Ocean shipping cost to most countries is $500 Local import fees and taxes not included.
 
 
$3350 260Hp

 

  • 350 Cubic inches 4.00" Bore, 3.47" stroke
    • 8.3:1 compression ratio. Reglar Gasoline (while GM advertises 8.5:1 I measured 8.27:1)
    • 260 HP @4400 rpm
    • 350 ft. lbs of torque @ 3600 rpm
    • Block cast iron, 2 piece rear main seal 4 bolt main
    • Crankshaft- Nodular Iron 1985 and older flywheel bolt pattern.
    • Powdered Metal Connecting rods
    • Cast Aluminum Pistons
    • G.M. High Volume Pump Oil Pump
    • Hydraulic Flat tappet Camshaft
      • Intake Lift-.383" Exhaust Lift-.401"
      • Intake Duration @ .050"- 194 Exhaust Duration @.050"- 202
      • Lobe Separation-112
    • Cylinder Heads- part # 14034808, casting #33417369, 1.94" Intake valve, 1.50" Exhaust Valve, 76cc Combustion Chamber, 7 Bolt style Exhaust Flange Standard, 85' and prior intake manifold bolt pattern. Perimeter bolt style Valve Covers. This head is very similar to the old #882 castings from the 1970's
  • Package Includes:

    • Edelbrock Performer EPS Intake Manifold
    • Edelbrock 4 Barrel 600 cfm electric choke, vacuum secondary Carburetor
    • Mechanical fuel pump
    • 14" Chrome Air Cleaner
    • 8" Harmonic balancer
    • 168 teeth Flex-plate
    • HEI Distributor, Spark Plugs, Wires
    • PCV and chrome breather
    • Water outlet with thermostat
    • Oil Filter
    • Oil Dipstick & Tube
    • Add $300 and I will run the motor for 1 hour under light load to break in the camshaft and look for any signs of problems.

      Additionally I will add a limited warranty for overseas purchase. Please ask for details.